Победил-таки с помощью Odiemus и всего форума!
AT91F_LowLevelInit(): Debug channel initialized
press any key to enter bootloader
Load U-BOOT from dataflash[c0008000] to SDRAM[20f00000]
Set PLLA to 180Mhz and Master clock to 45Mhz and start U-BOOT
AT91F_ResetRegistersÿ
U-Boot 1.1.1 (May 4 2006 - 11:47:26)
U-Boot code: 20F00000 -> 20F1BC3C BSS: -> 20F20554
RAM Configuration:
Bank #0: 20000000 32 MB
Unknown flash manufacturer 0x00900090
Flash: 0 kB
DataFlash:AT45DB642
Nb pages: 8192
Page Size: 1056
Size= 8650752 bytes
Logical address: 0xC0000000
Area 0: C0000000 to C0007FFF (RO)
Area 1: C0008000 to C001FFFF (RO)
Area 2: C0020000 to C0027FFF
Area 3: C0028000 to C083FFFF
In: serial
Out: serial
Err: serial
eth: setting MAC address to 12:34:56:78:9a:bc
PHY not connected!!
Link: 100baseTX Full Duplex
Hit any key to stop autoboot: 0
## Booting image at 20a00000 ...
Image Name:
Image Type: ARM Linux Kernel Image (gzip compressed)
Data Size: 1124113 Bytes = 1.1 MB
Load Address: 20008000
Entry Point: 20008000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
## Loading Ramdisk Image at 20c00000 ...
Image Name:
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 1807723 Bytes = 1.7 MB
Load Address: 20288000
Entry Point: 20288000
Verifying Checksum ... OK
Starting kernel ...
Linux version 2.6.16 (root@heavy) (gcc version 3.4.6) #16 Sat May 6 16:31:56 MSD
2006
CPU: ARM920Tid(wb) [41129200] revision 0 (ARMv4T)
Machine: Atmel AT91RM9200-DK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 180 MHz, master 45 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
Built 1 zonelists
Kernel command line: root=/dev/ram rw initrd=0x20288000,0x500000 ramdisk_size=50
00 mtdparts=AT45DB642.spi0:0x2A000(boot)ro,0x136000(kernel)ro,0x200300(initrd)ro
,-(filesystem) console=ttyS0,115200 mem=64M
AT91: 128 gpio irqs in 4 banks
PID hash table entries: 512 (order: 9, 8192 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 64MB = 64MB total
Memory: 57324KB available (1868K code, 406K data, 88K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
checking if image is initramfs...it isn't (no cpio magic); looks like an initrd
Freeing initrd memory: 5120K
NET: Registered protocol family 16
Generic PHY: Registered new driver
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) © 2001-2003 Red Hat, Inc.
io scheduler noop registered
io scheduler anticipatory registered (default)
AT91 Real Time Clock driver.
AT91 SPI driver loaded
AT91 Watchdog Timer enabled (5 seconds, nowayout=1)
at91_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a AT91_SERIAL
at91_usart.1: ttyS1 at MMIO 0xfffc4000 (irq = 7) is a AT91_SERIAL
RAMDISK driver initialized: 16 RAM disks of 5000K size 1024 blocksize
at91_ether: probe of at91_ether failed with error -1
at91_dataflash: AT45DB642 detected [spi0] (8650752 bytes)
4 cmdlinepart partitions found on MTD device AT45DB642.spi0
Creating 4 MTD partitions on "AT45DB642.spi0":
0x00000000-0x0002a000 : "boot"
0x0002a000-0x00160000 : "kernel"
0x00160000-0x00360300 : "initrd"
0x00360300-0x00840000 : "filesystem"
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 23, io mem 0x00300000
usb usb1: Product: AT91 OHCI
usb usb1: Manufacturer: Linux 2.6.16 ohci_hcd
usb usb1: SerialNumber: at91
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
at91_i2c at91_i2c: AT91 i2c bus driver.
Advanced Linux Sound Architecture Driver Version 1.0.11rc2 (Wed Jan 04 08:57:20
2006 UTC).
usbcore: registered new driver snd-usb-audio
ALSA device list:
No soundcards found.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Compressed image found at block 0
RAMDISK: incomplete write (8192 != 32768) 5111808
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 88K
init started: BusyBox v1.1.2 (2006.05.05-15:29+0000) multi-call binary
Starting system...
usb 1-2: new low speed USB device using at91_ohci and address 2
usb 1-2: device descriptor read/64, error -110
Configuring loopback interface...
Configuring eth0: 192.168.2.77...
SIOCSIFADDR: No such device
usb 1-2: device descriptor read/64, error -110
SIOCGIFFLAGS: No such device
Starting telnetd...
BusyBox v1.1.2 (2006.05.05-15:29+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
[root@AT91RM9200 /]$usb 1-2: new low speed USB device using at91_ohci and addres
s 3
usb 1-2: device descriptor read/64, error -110
usb 1-2: device descriptor read/64, error -110
usb 1-2: new low speed USB device using at91_ohci and address 4
usb 1-2: device not accepting address 4, error -110
usb 1-2: new low speed USB device using at91_ohci and address 5
usb 1-2: device not accepting address 5, error -110
[root@AT91RM9200 /]$
Только, какого хрена u-boot у меня пишет 32 ??? Я его кстати так и не смог собрать