Добрый день,

Есть ли в fpga xilinx (virtex4/virtex5/spartan3) хардовая защита от перегрева аналогичная температурной защите вторичных источников питания?

Например как у ti ptb78560A:

Overtemperature Protection
Overtemperature protection is provided by an internal temperature sensor, which monitors the temperature of
the converter PCB (close to pin 1). If the PCB temperature exceeds a nominal 115 ° C, the converter shuts down.
The converter then automatically restarts when the sensed temperature falls to approximately 105 ° C. When
operated outside its recommended thermal derating envelope (see data sheet derating curves), the converter
typcially cycles on and off at intervals from a few seconds to one or two minutes. This is to ensure that the
internal components are not permanently damaged from excessive thermal stress.

То есть при нагреве до допустим 100°C fpga отключается, остывает до какой либо температуры и потом включается.
Или fpga будет греться пока не сгорит?