J-Link problem with access breakpoint Опции

[Gyoergy Dozsa]

Setting access break point slown down the program execution in target with message:
Application does not run in real time because of conditional breakpoint(s) !
But, preakpoint is unconditional:
BS Write I2CCount, 1
Problem is in debugger, because this works fine udner CrossWorks.

[defunct]

I think you gave not enough info to clarify the problem. What MCU and what software do you use?

common measures:
Get the latest update for J-Link from segger web site. Replace the driver, used by software caused the problem, with the latest segger update.
Remove flash breakpoints in j-link driver options, also remove all breakpoints of your application... Setup only one breakpoint and try to debug again..