SIM900 в роли модема для ПК(через COM port) Опции

[_saper_]

Здравствуйте.
Может кто видел реализацию драйвера какого-нибудь или какой-нибудь проект, где комп воспринимает SIM900 как модем для выхода в сеть. Желательно конечно для linux, но я вообще ничего не нашел

Спасибо.

[_saper_]

Waldelk мне кажется что wvdial именно то что мне нужно. буду надеяться что в ядре планшета уже всё есть))

нашел даже коекакие инструкции



1) I never could get a 100% stable 3G connection 24/7 running. Sometimes they lose the connections (sometimes the provider is responsible for it, sometimes the usb-dongle itself). Newer dongles are better.


2) After testing betavine, and some other tools … I went back to wvdial … easy and 99% stable

3) you need 3 files wvdial & USB_ModeSwitch & USB_ModeSwitch_data.

Important: wvdial has to be build for the Arm architecture, I don`t know, if this is done for the Raspberry Pi … if not (maybe larson ??? should contact carl at excito, who has done this for the excito bubba)

4) usb-dongle, there are a lot dongles on the market, but the often are the same. To start I would suggest a dongle which is not brand-new and
Important: it should be in the USB_ModeSwitch_data, it saves a lot of time

5) Install wvdial & USB_ModeSwitch & USB_ModeSwitch_data per

apt-get install …

6) Edit wvdial.conf with your provider data (this example is for drei.at)

------ /etc/wvdial.conf --------------

Code: Select all
[Dialer Defaults]
Area Code =
Ask Password = 0
Auto DNS = 1
Baud = 460800
Carrier Check = 0
Compuserve = 0
Dial Command = ATD
DialMessage1 =
DialMessage2 =
Force Address =
ISDN = 0
Idle Seconds = 3000
Init1 = ATZ
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Init3 = AT+CGDCONT=1,"IP","drei.at"
Modem = /dev/ttyUSB0
Modem Type = Analog Modem
New PPPD = yes
Password = ;
Phone = *99#
Stupid Mode = 1
Username = ;
Auto Reconnect = On

------ end of /etc/wvdial.conf ------


The best way is *NOT* to use SIM pin codes


6) Edit /etc/network/interfaces and add this lines:

auto ppp0
iface ppp0 inet wvdial


7) Test

Type * wvdial * and you should get a connection
Contrl Z and then type bg

restart the Raspberry Pi and you should


8) For setting up a dyndns.org address

I use the linux-client: ddclient : http://sourceforge.net/apps/trac/ddclient/

9) now you could connect to your Raspberry Pi – Drone with your dyndns.org adress

и вот ещё ссылка

http://www.starterkit.ru/html/index.php?na...=8028&num=3


жду пока приедет планшет, а потом решу что дальше заказывать

Сообщение отредактировал _saper_ - Jan 9 2014, 17:00