|
Может быть так ?
1.6.2 Hardware flow control (RTS/CTS flow control)
Hardware flow control achieves the data flow control by controlling the RTS/CTS line. When the data transfer should be suspended, the CTS line is set inactive until the transfer from the receiving buffer has completed. When the receiving buffer is ok to receive more data, CTS goes active once again.
To achieve hardware flow control, ensure that the RTS/CTS lines are present on your application platform.
AT+IFC Set TE-TA local data flow control
+IFC: <dce_by_dte>,<dte_by_dce>
<dce_by_dte> specifies the method will be used by TE at receive of data from TA
0 None
1 XON/XOFF, don’t pass characters on to data stack
2 RTS flow control
3 XON/XOFF, pass characters on to data stack
<dte_by_dce> specifies the method will be used by TA at receive of data from TE
0 None
1 XON/XOFF
2 CTS flow control
Сообщение отредактировал CADiLO - Mar 13 2007, 17:27
--------------------
Не можна втрачати надію. Не можна здаватися до останньої миті. Можливо саме вона, остання мить, принесе весну, яка стане початком нового життя.
|
Sim300D, CSD
Feb 27 2007, 14:35
