XJTAG драйва!, очередная китайская поделка Опции

[Make_Pic]

Сам не тестил!

1. Support both ARM7 and ARM9
2. Support RDI 1.5.0 and 1.5.1
3. Support ADS1.2 and SDT2.5.1
4. Support wiggler, sdt jtag and user defined interface

The software has been tested using s3c4510, s3c44b0, s3c2410, s3c2440 and LPC2104. Hopt it is useful to you.

Install:
Install the software with administrator right.

Config:
In AXD or ADW, select xdi.dll under the installation directory.

 XJTAG_Setup.zip ( 413.89 килобайт ) Кол-во скачиваний: 371

[Make_Pic]

Сам не тестил!

 XJTAG_Setup.zip ( 413.89 килобайт ) Кол-во скачиваний: 371

Вдогонку:

Thanks for programm, but "Wiggler" definitions nead some correctins.
Original (or with corerect schematics) "Wiggler":
nTRST use direct buffer element (without inversion by n-p-n tranzistor) from DB25 Pin6 D4
nSRST use inverted (open colector) signal by n-p-n transzistor from Pin2 D0

Without these correction "Wiggler" not working because XJTAG put "0" level to Pin6 D4, and all time nTRST signal is activ.

When I get XJTAG first version (BETA 0.1), I try it, but get "Target not found" .....
Now I making some research by oscillscope .....

[Dainis]

Сам не тестил!

 XJTAG_Setup.zip ( 413.89 килобайт ) Кол-во скачиваний: 371

Вдогонку:

Thanks for programm, but "Wiggler" definitions nead some correctins.
Original (or with corerect schematics) "Wiggler":
nTRST use direct buffer element (without inversion by n-p-n tranzistor) from DB25 Pin6 D4
nSRST use inverted (open colector) signal by n-p-n transzistor from Pin2 D0

Without these correction "Wiggler" not working because XJTAG put "0" level to Pin6 D4, and all time nTRST signal is activ.

When I get XJTAG first version (BETA 0.1), I try it, but get "Target not found" .....
Now I making some research by oscillscope .....

А у меня вчера было лень это перепостить сюда ....

Dainis