2 Mikle Klinkovsky - кусок письма ниже - думаю ничего в этом страшного не будет, если приведу кусок.. На счёт наличия координат падов и виасов в герберах - я в курсе, тут думаю другое...
2 arttab - понимаете , я так понял с письма (ниже привёл текст) - это именно герберы, а не отчёты...
-----------------
....what we need is the gerber output which provides the X,Y co ordinates of each pads and vias of the new PCB.
This would provide input to the VISUAL FAULT INDICATOR module of the INTELLITECH.
With this , we would be in a position to visually present where is the short or open in the PCB.
The output format would be provide the pin no and its corresponding X,Y co ordinate position in the PCB.
The output requested is generally available in all the CAD software.
-----------------
Есть у кого идеи - что имелось ввиду ?