hello
i'm beginner and i have the same problem as Andrejka
i try atmega16, 32 and 162 and the resultat was the same
at start the LCD show only "SHT11 MONITOR" on first line
when i disconnect the 10 k pull-up resistor from DATA line of SHT11 sensor it didn't show time and date and the other parameters aren't correct, only heat position swich is correct
i mentioned i'm using CodevisionAvr to compile and i tryed the sugestion metioned in previously posts
i attach the pictures
any sugestion to make it work will be helpfull
best regards
Сообщение отредактировал radu - Jan 16 2009, 10:42
Эскизы прикрепленных изображений