Матлаб/симулинк - не загружается модель, не находит компоненты Опции

[_Ivana]

Мне прислали модель для симулинка, открывал в релизе 2012а - сообщал что файл был создан в релизе 2013а и далее кучу ошибок. Скачал с ФТП и поставил 2013а,ошибки те же:

Warning: Cube (blockdiagram.xml, line 640): This model contains objects of class
"SSC.SimscapeCC" that can not be instantiated. If you save this model, the
information associated with these objects will be lost.
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196
Warning: Cube (blockdiagram.xml, line 643): This model contains objects of class
"MECH.SimMechanicsCC" that can not be instantiated. If you save this model, the
information associated with these objects will be lost.
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196
Warning: Cube (blockdiagram.xml, line 674): This model contains objects of class
"simmechanics.ConfigurationSet" that can not be instantiated. If you save this
model, the information associated with these objects will be lost.
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196
Warning: Cube (blockdiagram.xml, line 677): This model contains objects of class
"simmechanics.DiagnosticsConfigSet" that can not be instantiated. If you save this
model, the information associated with these objects will be lost.
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196
Warning: Cube (blockdiagram.xml, line 689): This model contains objects of class
"simmechanics.ExplorerConfigSet" that can not be instantiated. If you save this
model, the information associated with these objects will be lost.
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196
Warning: Unable to load block diagram 'mblibv1'
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196
Warning: Viewer 'Cube/Floating Scope1' was previously observing the signal
originating from block 'Энкодер', output port 1. That signal is no longer valid
and will be removed from the viewer's signal list
In general\private\openmdl at 13
In general\private\openslx at 9
In open at 159
In uiopen at 196

но окно симуляции открывается. хотя на почти всех блоках написано "Bad link" и при попытке запустить выдается

Failed to load library 'mblibv1' referenced by 'Cube/Joint Initial Condition'

Caused by:
Unable to load block diagram 'mblibv1'

Что может быть причиной? С симулинком встречаюсь впервые )