При переходе от идеальной модели триггера к триггеру 74HC74 модель перестаёт работать.
Было:
![](https://s33.postimg.cc/3ss4wa6v3/Screenshot_9.png)
![](https://s33.postimg.cc/gwxp8zecf/Screenshot_10.png)
Стало:
![](https://s33.postimg.cc/e2ujvip0v/Screenshot_7.png)
![](https://s33.postimg.cc/7ce2m3han/Screenshot_8.png)
Виден какой-то начальный импульс, а затем сигнал переходит в ноль, что не верно.
Симулятор после прогона выдаёт ошибку 3 digital warning messages See numerical output
А там
Digital Warning
Preb input width violation at t=1.2e-008
Device X6.U1
Required Preb input width is 2.5e-008
Measured Preb input width is 1.2e-008
Digital Warning
Clrb input width violation at t=1.2e-008
Device X6.U1
Required Clrb input width is 2.5e-008
Measured Clrb input width is 1.2e-008
Digital Warning
Preb input width violation at t=1.2e-008
Device X6.U1
Required Preb input width is 2.5e-008
Measured Preb input width is 1.2e-008
Что это?
Что делать?