Цитата(asen @ Dec 15 2016, 07:25)
Вопрос к коллегам какой отладчик вы используете для работы с MKV58 ? для ядра Cortex M7 именно по SWD ? Для М4 я использовал j-link V8 от он послал меня лесом с ядром M7 что то надо купить более современное ! Что ?
Cortex-M7 is supported by
J-Link Base / Plus V9 and higher
J-Link Ultra+ / Pro V4 and higher
Также STLINK v2 никто не отменял +
http://openocd.org:Цитата
Open On-Chip Debugger 0.10.0-dev-00200-gdb56a3b (2016-02-09-16:12)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.htmlInfo : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_deassert_srst
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : clock speed 1800 kHz
Info : STLINK v2 JTAG v24 API v2 SWIM v11 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.216820
Info : STM32F756.cpu: hardware has 8 breakpoints, 4 watchpoints
Open On-Chip Debugger 0.10.0-dev-00200-gdb56a3b (2016-02-09-16:12)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.htmlInfo : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_deassert_srst
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : clock speed 1800 kHz
Info : STLINK v2 JTAG v24 API v2 SWIM v11 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.216820
Info : STM32F756.cpu: hardware has 8 breakpoints, 4 watchpoints