Не шьется LM3S6965 Опции

[vasta]

Здравствуйте, уважаемые господа.
Хочу поделиться проблемой.
На большой серии плат вылез какой-то косяк
Шью с J-flash v4.08
Где то на 15-20% плат выдается ошибка block verification error.
Вот полный рапорт

Auto programming target (19590 bytes, 1 range) ...
- Connecting ...
- Connecting via USB to J-Link device 0
- J-Link firmware: V1.20 (J-Link ARM V7 compiled Jun 30 2009 11:05:27)
- JTAG speed: 200 kHz (Auto)
- Initializing CPU core (Init sequence) ...
- Initialized successfully
- JTAG speed: 200 kHz (Auto)
- CPU clock frequency: 0 kHz
- J-Link found 1 JTAG device. Core ID: 0x3BA00477 (Cortex-M3)
- Connected successfully
- Erasing affected sectors ...
- 20 of 256 sectors affected to erase, 1 range
- Affected sectors 0 to 19 (0x0 - 0x4FFF)
- RAM tested O.K.
- Erasing sector 0
- Erase operation completed successfully
- Programming target (19590 bytes, 1 range) ...
- ERROR: Programming failed @ address 0x00000004 (block verification error)
- ERROR: Failed to program target
- ERROR: Failed to auto program target
Disconnecting ...
- Disconnected

В чем проблема и можно ли ее победить?