Помощь - Поиск - Пользователи - Календарь
Полная версия этой страницы: cannot back annotate in OrCAD Layout Plus
Форум разработчиков электроники ELECTRONIX.ru > Печатные платы (PCB) > Разрабатываем ПП в САПР - PCB development
pavel47
Hello

I cannot back annotate from Layout.
I swaped in layout 2 gates from 2 different components of the same type.
When I try to back annotate, I receive the message:

External pin swap (U2.7 and U1.7) not supported.

The same message for other 2 pins of gate.

So, I can't annotate to capture the gate's swapping from 2 different components???

Thanks in advance.

Pavel.
Alex11
Yes, you can use gates and pin swap only in one chip.
pavel47
Thanks Alex

But this feature isn't documented in Layout Plus help...
dm_mur
Цитата(pavel47 @ Dec 19 2005, 20:37) *
Hello

I cannot back annotate from Layout.
I swaped in layout 2 gates from 2 different components of the same type.
When I try to back annotate, I receive the message:

External pin swap (U2.7 and U1.7) not supported.

The same message for other 2 pins of gate.

So, I can't annotate to capture the gate's swapping from 2 different components???

Thanks in advance.

Pavel.


You can use swaping in the same type different components. In data of packing of a component check up an option "internal swap gate only"
pavel47
... option "internal swap gate only".

Thanks
Для просмотра полной версии этой страницы, пожалуйста, пройдите по ссылке.
Invision Power Board © 2001-2025 Invision Power Services, Inc.