Кит новый. Брал за 158 в сумме. Из минусов - нет DDRAM, мне он оказался нужен. http://www.microsemi.com/fpga-soc/design-r...-evaluation-kit
http://www.digikey.com/product-detail/en/A...1011-ND/2744958 113 USD + 45 доставка + подписывание экспортных бумаг. Отдам за 120. PS программатор такому киту не нужен - он распаян на плате. Бонусом - ответный разъем на шинку IO. C АРМ частью можно работать через MT-Link. Но можно и все делать все через встроенный.
Код
A2F200M3F-FGG484
200,000 System FPGA gates, 256 KB flash memory, 64 KB SRAM, and additional distributed SRAM in the FPGA fabric and external memory controller
Peripherals include Ethernet, DMAs, I2Cs, UARTs, timers, ADCs, DACs and additional analog resources
Refer to the SmartFusion product page for full device information
SPI-flash memory connected to SPI_0 on the device
USB connection for programming and debug from Microsemi's design tools
USB to UART connection to UART_0 for HyperTerminal examples
10/100 Ethernet interface with on-chip MAC and external PHY
RVI header for application programming and debug from either Keil or IAR Systems
Mixed-signal header for daughter card support
User Inputs and Outputs
OLED display with I2C interface connected to I2C_0 on the device
First-order ΣΔ DAC (sigma delta) output with 12-bit 500 Ksps update rate
Potentiometer used to vary voltage input for voltage and current monitoring
8 LEDs connected to the FPGA fabric for FPGA demonstration
200,000 System FPGA gates, 256 KB flash memory, 64 KB SRAM, and additional distributed SRAM in the FPGA fabric and external memory controller
Peripherals include Ethernet, DMAs, I2Cs, UARTs, timers, ADCs, DACs and additional analog resources
Refer to the SmartFusion product page for full device information
SPI-flash memory connected to SPI_0 on the device
USB connection for programming and debug from Microsemi's design tools
USB to UART connection to UART_0 for HyperTerminal examples
10/100 Ethernet interface with on-chip MAC and external PHY
RVI header for application programming and debug from either Keil or IAR Systems
Mixed-signal header for daughter card support
User Inputs and Outputs
OLED display with I2C interface connected to I2C_0 on the device
First-order ΣΔ DAC (sigma delta) output with 12-bit 500 Ksps update rate
Potentiometer used to vary voltage input for voltage and current monitoring
8 LEDs connected to the FPGA fabric for FPGA demonstration