В даташите к модему читаю
AT+CBST Select Bearer Service Type (ver. 3) Set command: AT+CBST=[<speed>,[<name>,[<ce>]]] Read command: AT+CBST? Displays the current setting. response: +CBST: <speed>,<name>,<ce> Test command: AT+CBST=? Shows if the command is supported.
Parameter: <speed>:
0 - Auto selection of baud setting. Default setting 7 - 9600bps V.32 12 - 9600bps V.34 14 - 14400bps V.34 15 - 19200bps V.34 16 - 28800bps V.34 39 - 9600bps V.120 43 - 14400bps V.120 47 - 19200bps V.120 48 - 28800bps V.120 71 - 9600bps V.110 (ISDN) 75 - 14400bps V.110 (ISDN) 79 - 19200bps V.110 (ISDN) 80 - 28800bps V.110 (ISDN)
<name>: 0 Asynchronous connection (UDI or 3.1kHz modem) - Default setting. 4 Data circuit asynchronous (RDI)
<ce>: 1 Non transparent - Default setting
Как они себя ведут на практике? есть ли у V.110 преимущества по сравнению с V.32 V.34? Ведь данные всё равно идут в цифре и я подозреваю, что эти все протоколы не более чем эмулируются для совместимости. Не так ли?
--------------------
The truth is out there...
|