Теперь к вопросу о повышении качества изображения. Т.к. используется внешний конденсатор для обеспечения режима автоматической регулировки оптической мощности (APC), стартовое значение его емкости я взял в соответствии с рекомендациями разработчика драйвера:
External capacitor modeIn applications where an external capacitor is required (see best performance recommendations below), the external capacitor mode must be enabled (pin CID = high). This connects the capacitor to the control circuit and additionally enables a pull-down current at pin CI to prevent this capacitor from being charged due to residual currents (cf. Electrical Characteristics No.406).
Best performance recommendationsThe operating point for the laser diode is stored in an on-chip capacitor. This permits a fast start-up but can make the regulated system unstable under certain conditions such as inadequate PCB layout. In these cases, an optional capacitor can be connected as close as possible to the chip, across pins CI and CIS.
.. 10 nF ..
BURST MODEIn controlled burst mode iC-NZN can pulse with up to 155 MHz. Controlled here means that a pre-set operating point is maintained during the burst phase. Therefore an operating point is settled first, for which pin REGE has to be high and the laser diode must be switched on. Once the operating point has been reached the laser diode can be switched off again. The operating point is stored in an on-chip capacitor and when pin REGE is set to low, the burst mode is activated. The pre-set operating point is maintained. For a longer burst mode, an external capacitor can be connected to pin CI. To prevent the laser current from rising due to residual currents, the capacitor is discharged then with a maximum of 2.6 μA (cf. Electrical Characteristics No. 406). As the capacitor is discharged gradually, the output level must be re-settled again after a certain period, depending on the admissible degradation of the laser output power.
В итоге получается следующее:
Т.е. возникает переменная оптическая плотность заливки черным. В начале строки избыток засветки, к окончанию строки - снижение. На скане это не видно, а на просвет видно.
После замены конденсатора CI на 100 нФ, с нетронутыми
настройками:
В итоге, финишная регулировка:
http://learn.watterott.com/silentstepstick/В архиве файлы модель и битовая карта.
TMC2130.zip ( 410.62 килобайт )
Кол-во скачиваний: 24Забыл сказать - вся печать выполнялась с разрешением 1200 dpi.
Забавы ради, дороги 0.12, 0.2.:
5._Altera.zip ( 2.79 мегабайт )
Кол-во скачиваний: 42
Сообщение отредактировал Alligator75 - Mar 4 2018, 11:45